Many of you have come across a blue screen while trying to install windows xp in your new laptop. This BSOD (Blue Screen Of Death) is due to the fact that your Windows XP does not have the SATA drivers which is required to detect your Hard Disk Drives. The solution to this is to integrate SATA drivers to your winxp CD, the following steps will let you do it.

If you don’t have Floppy Disk Drive especially on a notebook. You still can install Win Xp by Slip streaming SATA driver into WinXp boot cd using nLite.

Here I will give step by step to make the Windows XP Installer CD that is equipped SATA drivers.

Conditions that must be fulfilled before you make the Installer CD Slipstream Windows XP:
1. Prepare a computer that use the Windows XP and CD/DVD-RW CD burn your ISO image.
2. Blank CD.
3. Windows XP Installer CD that will be made slipstream.
4. Net Framework 2.0
5. nLite
6. AHCI SATA Driver

Steps:
1) Get your Windows XP installation disk and copy the contents to a new folder(I named it “WinXp”).
2) Extract the SATA drivers you downloaded into a folder
3) Run nLite >> choose “Next”.
[spoiler][/spoiler]
4) Now, locate the Windows folder(for me, it’s “WinXp”).
[spoiler][/spoiler]
5) Next again and you will come to “Presets”. Ignore this by choosing “Next” again.
[spoiler][/spoiler]
6) In “Task Selection”, choose “Drivers” and “Bootable ISO” by high-lighting them.
[spoiler][/spoiler]
7) Choose “Insert” >> “Single driver”
[spoiler][/spoiler]
Browse to the SATA driver folder and select either one of the .INF file, I choose “iaahci.inf”.
[spoiler][/spoiler]
9) A screen like below will pop-up, make sure it’s “Textmode driver” ( This is the most important step ) and select all of them by holding CTRL+A key and choose “OK”
[spoiler][/spoiler]
10) You shall see something like this. Choose “Next” and you will be prompted.
[spoiler][/spoiler]
11) Choose “Yes” to start the process.
[spoiler][/spoiler]
12) Let it finish and choose “Next”.
[spoiler][/spoiler]
13) Finally, you can create your project as ISO image or burn it directly to CD-R under “Mode”. I choose “Direct Burn”. You can put anything for “Label” but not too long. Choose “Burn” and you will be prompted again.
[spoiler][/spoiler]
14) Choose “Yes” to burn it to CD-R. Wait for it to finish and choose “Next”
[spoiler][/spoiler]
15) Choose “Finish” to exit nLite.
[spoiler][/spoiler]
Thats all You can now boot your laptop with this CD and install Windows Xp with out Blue screen showing.

If you are was successful create a slipstream Windows XP installation, just install like as usual, but if your instalation fail it means that there are errors in making the Windows XP slipstreaming or if you use Windows Vista before, You must delete the partition and re-create the partition, which is used for WindowsVista is (be careful! you can lose your data if you make mistake, Make sure all important data was backups and save in the safe place).